LoRa® on-premise - at Home and in the Office documentation


◄ Previous: Join Door and Window Sensor Next: Join the Temperature and Humidity Sensor ►

Join Your Devices to the Network

Join the Motion Sensor

  1. Click Applications in the menu on the left.

  2. Click on the Motion Sensor Application you created earlier.

  3. The devices registered to this application appear. Click on the link in the DevEUI field of the Motion device.

  4. Select the Activation tab for the device, it will state This device has not (yet) been activated.

  5. Pull the plastic tab out of the motion device to connect the battery.

  6. After a few minutes, refresh the page and select the Activation tab again and you should see the door/window sensor has come online.

    Warning

    If you do not see the online status after five minutes, check you entered the NwkKey into the Application Key field, and make sure the DevEUI was correctly entered.

◄ Previous: Join Door and Window Sensor Next: Join the Temperature and Humidity Sensor ►